Sta-Rite EC240110T Effluent Pump
Our best, the EC2 Series submersible pumps are constructed of rugged cast iron, with a non-clog vortex impeller typically used in septic tank effluent applications.
Key Features:
- HP - 4/10
- Amps. - 12.5
- Volts - 115
- Cycles - 1/60
- Cord Length - 10
- Switch Type - Tethered
Specifications:
BODY CONSTRUCTION: Cast Iron and Fiberglass reinforced polypropylene
HORSEPOWER: 4/10 hp
MAXIMUM HEAD: 32'
MAXIMUM CAPACITY: 62 GPM
FLOW AT 10' LIFT: 54 GPM
MOTOR: 4/10 HP (1550 RPM); Shaded pole with thermal overload
SWITCH: Available with no float (Manual op.) or with Tethered Float
IMPELLER: Fiberglass reinforced Noryl® with threaded brass insert
SHAFT SEAL: Mechanical, carbon/ceramic
BEARINGS: Upper sleeve and lower ball bearings, oil lubricated
EXTERIOR HARDWARE: Stainless steel
MINIMUM SUMP DIAMETER: Simplex = 18" (457mm) , Duplex = 30" (762mm)
DISCHARGE SIZE: 1-1/2" (38mm) NPT
MAXIMUM SOLIDS HANDLING SIZE: 1/2” (12.7mm)
AMP DRAW: 12.5 amps at max flow
POWER CORD: 10' or 20' water resistant 16-3 gauge, type SJTW-A/SJTW with integrally grounded3-prong plug.
VOLTAGE: 115 Volt, 60 Hz
MAXIMUM LIQUID TEMP: 130°F (55°C)
